A how-to guide in removing your old window tints

Window tinting Gaithersburg MD is trendy for cars since they can effectively prolong the life of a car. These thin films protect you and your car. Window tints can also be used to give your car additional privacy and enhance its aesthetics. All these benefits, however, come at a cost.

Window tints, like other investments, can be expensive. Window tints can be costly, so car owners want to ensure they get the most for their money. The life expectancy of window tints will depend on their quality, the amount of sunlight they were exposed to, and their installation quality. Window tints of low quality will usually deteriorate faster than those of high quality. You will get what you pay for, it is obvious.

Window tints will eventually deteriorate, regardless of whether they are premium or cheap. Discoloration and bubble formation are two of the most obvious signs that your window tints need to be replaced. To avoid a messy mess, window tints are usually replaced by professionals. If you need to delay your tint replacement, you can remove the old tints first, so your vision is not obstructed.

What do you need?

  • Razor Blades
  • Dishwashing soap
  • Soft cloth
  • Spray bottle
  • Water
  • Glass cleaner

What should I do?

Once you have all your materials, you can simply follow these steps.

Take a small section from one corner of the film

Make a small incision at the corner of your film with the razor blade. As long as the blade is not pressed too hard, your windshield or windows will not be easily scratched.

Slowly peel the film off

Start slowly peeling the window tint, starting at the corner that you have cut. This step should be done slowly to remove all of the tints at once. If the film is not completely removed, you can use the razor blade to lift the edges. Then you can continue peeling until everything is gone.

Use a soapy water solution to clean the windows

Mix a little dishwashing soap with water in a spray bottle. It doesn’t matter how precise you are with the measurements. After you have finished preparing the mixture, spray generously on the areas that are exposed to adhesive.

Allow it to sit and soak

Let the soapy mixture sit for a while before you spray it. This allows the soapy water to soften the adhesive and makes it easier to move on to the next step.

Remove the adhesives left behind

To remove the adhesive residue from the glass, you will need a razor blade. You don’t have to scratch your windows if you are concerned about scratching them. You can spray more soapy solution to remove any residue if the glass starts drying.

Clean windows

After you have removed all the tint and adhesive residue from your windows, it is time to clean them. All you need is a glass cleaner, a soft cloth and a soft cloth to clean your windows. You can also use a dishwashing soap-water mixture if you don’t have a glass cleaner. You should avoid using ammonia-based cleaners. Abrasive cleaners should be avoided as they can cause scratches.

It is not difficult to remove old window tints. This will prepare your vehicle for a new film. To ensure your next window tints are perfect, be sure to not scratch the windows.

Getting car window tinting Pearland TX will be a perfect choice if you are looking for a window tint in the area.